
106
106
- 15/18/20BT-7, 16/18/20B-7 Traction Master (03) Test .
Motor Voltage
Voltage supplied to the motor by the controller expressed in % of full battery voltage.
Frequency
Frequency of the voltage and current supplied to the motor.
Encoder
The speed of the motor in Hz. This information comes from the motor Encoders
Slip Value
Difference in speed between the rotating field and the motor shaft (rotator).
Root Mean Square value of the motor current. (RMS Power or the Root Mean Square of
the Power is the average power in an AC circuit. It is like taking the average of the
absolute value of the AC Power).RMS = (1/SQR2).(Peak)
Temperature
Temperature of the aluminum heat sink, holding the MOSFETS. (Controller)
Motor Temperature
Temperature of the motor itself. #1: RH and #2: LH
Accelerator
Voltage coming from accelerator pedal ( LH side = Voltage / RH side = percentage).
Steer angle
This is the indication of the angular position of the steering wheel
Indication of speed reduction of the inner wheel during curving
Forw switch
Status of FW switch
Back switch
Status of REV switch
Enable switch
Status of enable switch
Seat switch
Status of seat switch
Cutback switch
Status of Speed Reduction Micro switch.
Status of brake pedal micro switch
Status of exclusive hydro switch
Value of poti on the brake pedal. (NOT FOR HYUNDAI).
Status of hand brake switch
This is the boost of the voltage supplied to the motor in load conditions
Battery voltage measured at the key switch input.
. This is the release switch inside accelerator pedal.
Comentários a estes Manuais